Clover will boot to windows but will stay on boot screen

[hackontsher 0]

I recently installed macOS Catalina on my HP envy x360 15-bp1xx since then I have not been able to boot into windows. I can however navigate to windows on clover, when I do it shows the windows logo on a small field of grey around it. MacOS boots fine and about 98% of it works. I have one M.2 NVME 25 Gig drive on it is a windows partition and a MacOS partition. In the clover configurator the windows partition shows up as windows basic volume, I’m not sure if that helps. 
my specs are:

Intel i5-8250U

geforce MX150

8 gigs of RAM

i am not very experienced with hackentoshes or MacOS so any help is greatly appreciated. 
Thanks in advance.

[Hackintosh 345]

The changes that you made in BIOS Could make it unable to boot into Windows, Try to Enable CSM in BIOS.

[hackontsher 0]

Enabling CSM, then booting into windows gives me the error “An operating system wasn’t found, try disconnecting any drives that don’t contain an operating system”.