Permanently saving npci=0x2000 -v

[subotica77 3]

I have problems permanently saving npci=0x2000 -v using Clover Configurator. My computer won't start without me adding this, so I added it in the Configurator. The next time I restarted my PC it worked great. But the third time I restarted, for some reason, it adds and extra space after -v, so It doesn't start up. I have to delete the extra space after -v in order to get it to boot. I checked the config file, and the space is not there, but it's added during startup. I tried changing the order and putting npci=0x2000 -v first, still same issue. It's a hit and miss. Sometimes it starts up fine, sometimes I have to go and delete the space. I also tried modifying it using a text editor... same issue.

My setup (Niresh Catalina):
Motherboard: Gigabyte GA-X99-Ultra Gaming (rev. 1.0)
CPU: Intel Core i7 6950X Processor Extreme Edition
Ram: Corsair DOminator Platinum 3200MHz, 64GB
GPU: XFX Radeon RX 580 GTS XXX Edition

Any ideas how to get it to permanently stick?

[subotica77 3]

I also noticed that sometimes it starts up without me deleting the extra space, and sometimes it doesn't. Any advice?

[Hackintosh Shop 248]

Catalina uses Clover bootloader.

• Use Clover Configurator to mount EFI Partition.
• Open config.plist from the mounted EFI Volume.
• Add boot-flags to it with using Clover Configurator.
• Save & Exit.